IMEKO TC4 Banner


The 2019 International Symposium of IMEKO TC4 

17-20 September, 2019 , Xi’an, China

(Submission system is now open: )

Extended Deadline for Short Paper Submission : March 01, 2019


The Technical Committee 4 of the International Measurement Conference (IMEKO) was established in 1984.

It works on theoretical and practical aspects of the measurement of electrical quantities by electronic instruments. TC4 provides a forum for the dissemination of ideas about electrical and electronic measuring techniques and principles of implementation of information and communication technology for the measurement and enhancement of the accuracy.

The 2019 International Symposium of IMOKO TC4, entitled “Electrical & Electronic Measurements Promote Industry 4.0”, will be held on 17-20 September 2019 in Xi’an, China.

We now invite you to submit, through conference website ,  a manuscript of no less than 4 pages in microsoft word as email attachment.

All manuscripts will be reviewed by experts of the Technical Program Committee, and final papers of those accepted will be presented in the Symposium either as oral reports or posters. All accepted papers will be published in the Proceedings of the symposium, which is indexed by the EI. Previous experience have shown that, a large number of papers accepted, after improvement, will be published in peer-reviewed journals, such as Measurement (special section), ACTA IMEKO electronic Journal.

Topics of interest:

              Direct Current and Low Frequency Measurements

              Radio Frequency, Microwave and Millimeter Wave Measurements

              Calibration, Metrology and Standards

              Traceability  and International Compatibility of Measurements

              Advanced Instrumentation Based Micro and Nanotechnologies

              Signal and Image processing

              Waveform Analysis and Measurements

              System Identification and Control

              Biomedical Measurements

              EMC Measurements

              Power and Energy Measurements

              Power Quality Assessment

              Time and Frequency Measurements

              Automated Test and Measurement Systems

              Measurement and Instrumentation for Industrial Applications

              Marine Instrumentation Technology

              Sensors and Transducers

              Virtual Measurement Systems

              Sensors Interoperability

              Wireless Sensor Networks

              Intelligent Measurement Circuits and Systems


Paper submission:

Participants may submit manuscripts through the online submission system available at, which also provides detailed requirements for paper submission.


Important submission dates:

4-Page Short Paper submission deadline:       March 1st, 2019                                                                         

Notification of acceptance:                              April 30th, 2019                                                                  

Final paper submission:                                 May 31st, 2019  


Thank you for your attention.


Contact person:   

Dr. Yunfeng LU

Tel: +86 10 64524501

Email: This email address is being protected from spambots. You need JavaScript enabled to view it.This email address is being protected from spambots. You need JavaScript enabled to view it.

National Institute of Metrology (NIM)

No.18, Bei San Huan Dong Lu, Beijing 100029, P.R. China